Pairing your Richmat HJC 18 control box with the HJH37 remote is essential for seamless operation of your adjustable bed. Follow these steps to establish a successful connection:

1. Ensure Proper Power Connection:
   • Verify that the adjustable bed is securely connected to a functioning power outlet.
   • Check for indicator lights on the HJC 18 control box to confirm it is receiving power.
2. Activate Pairing Mode on the HJH37 Remote:
   • Simultaneously press and hold the Head Lift and Foot Lift buttons on the remote for a few seconds until the remote’s indicator light begins to flash, indicating it is in pairing mode.
3. Enable Pairing Mode on the HJC 18 Control Box:
   • Locate the pairing button on the HJC 18 control box, typically found near the power cord.
   • Press and hold the pairing button for approximately 3 seconds until you hear a twin beep, signaling that the control box is ready to pair.
4. Complete the Pairing Process:
   • Once both devices are in pairing mode, they should automatically connect.
   • Test the connection by adjusting the bed’s position using the remote. If the bed responds accordingly, the pairing is successful.

Troubleshooting Tips:

• Check Battery Levels: Ensure the HJH37 remote has sufficient battery power, as low batteries can impede the pairing process.
• Proximity: Keep the remote close to the control box during pairing to prevent signal interference.
• Reset Devices: If pairing fails, disconnect the control box from the power source for 30 seconds, then reconnect. Also, remove and reinsert the remote’s batteries before attempting the pairing process again.